Choose the page that matches the roof question.
Repair, replacement, coatings, inspections, and maintenance planning for flat and low-slope commercial roofs.
Commercial Roof Leak Repair
Tracing a leak to its true source matters more than chasing the stain on the ceiling tile, especially on the ponding-prone flat roofs common across downtown Washington. We isolate the entry point, then make a lasting repair.
Open details
Wind Uplift Roof Repair
Edge failures and loose fasteners let regional wind get under a membrane and peel it, so we re-secure perimeters and field attachment to the uplift ratings DC's storm fronts demand.
Open details
Humidity & Moisture Damage Roof Repair
The Potomac region's persistent humidity pushes moisture into roof assemblies, saturating insulation and corroding fasteners from below. We find the wet zones and dry or replace them before rot sets in.
Open details
Storm Damage Roof Repair
Nor'easters and remnant tropical systems drive wind and rain hard against DC roofs, lifting edges and opening seams. We assess the damage, document it, and make the building secure again.
Open details
Commercial Roof Tear-Off & Replacement
A full tear-off exposes wet insulation and tired decking that a recover would only hide. We plan dumpster placement, crane picks, and tenant access so a District replacement stays on schedule and dried-in nightly.
Open details
Commercial Re-Roofing
When patch-on-patch repairs stop holding, a full re-roof resets the assembly. We tie the system choice to the building's drainage, insulation value, and how long ownership plans to hold the property.
Open details
Occupied Building Re-Roofing
Reroofing over a busy building means the tenants never feel it, so we stage materials, control odor, and dry the deck in nightly across Washington's occupied offices and storefronts.
Open details
Hail Damage Roof Restoration
After a hailstorm bruises a membrane, fractures show up months later as leaks. We document impact marks for the carrier and restore the system before the damage spreads across a DMV roof.
Open details
Roof Recover & Overlay
When the deck and insulation test dry, a recover overlay adds a fresh membrane without a costly tear-off. We verify the existing roof qualifies before overlaying a single-ply or coating in the DMV.
Open details
Insulation & Recovery Board
Adding insulation or a recovery board during a reroof raises R-value and gives the new membrane a clean, even substrate. We size the buildup to code and to the District's heating and cooling demands.
Open details
Preventive Maintenance Programs
A standing maintenance agreement spreads roof care across the year and keeps a paper trail for the warranty. Visits are timed to catch what DC's freeze-thaw winters and humid summers leave behind.
Open details
Commercial Roof Preventive Maintenance Program
Scheduled spring and fall visits keep small membrane problems from becoming insurance claims. Each program is sized to the roof's age and the freeze-thaw cycling that wears DMV roofs every winter.
Open details
Silicone Roof Coatings
Silicone shrugs off the ponding water that collects on aging flat roofs and reflects the summer sun, restoring a weathered membrane without a tear-off. It is a strong restoration choice for DC's wet climate.
Open details
Acrylic Roof Coatings
A reflective acrylic coating buys aging single-ply and metal roofs more service life while cutting the heat that DC's humid summers drive into the deck. We confirm the substrate is sound and dry before any topcoat goes down.
Open details
Commercial Roof Inspection
A documented walk-through catches splits, open seams, and clogged drains before a DC nor'easter finds them first. Findings come back with photos and a prioritized punch list, not a sales pitch.
Open details
Drone & Thermal Roof Inspection
Aerial and thermal imaging surveys a large campus roof in a single visit and flags trapped moisture without a crew walking every square. It is a fast first look for sprawling Maryland and Virginia facilities.
Open details
Emergency Tarp Dry In
After storm damage opens a roof, a fast tarp and dry-in stops water before it reaches tenants and inventory. Crews mobilize across the DMV to secure the building until a permanent fix can be scoped.
Open details
Metal R-Panel Roofing
Exposed-fastener R-panel is a workhorse on warehouses and ag-style buildings, but its many penetrations need watching. We repair or re-fasten panels and reseal laps before regional wind finds the gaps.
Open details
University and College Campus Roofing
Large campuses run dozens of roof assemblies of different ages, so we help facilities teams prioritize, budget, and phase work around academic calendars at DC-area colleges.
Open details
KEE Single-Ply Roofing
KEE membranes resist the grease, chemicals, and UV that shorten the life of ordinary single-ply on restaurant and lab roofs. It is a durable single-ply option for demanding DC-area rooftops.
Open details
Energy-Efficient Cool Roof Installation
A high-albedo cool roof trims cooling bills through Washington's long, sticky cooling season and helps buildings meet the District's energy benchmarking goals. We match the reflective system to the existing deck.
Open details
Mixed-Use Development Roofing
Mixed-use blocks stack retail, offices, and apartments under one roof, so we coordinate around tenants and amenity decks while keeping the membrane and drainage right for every use below.
Open details
Retail and Shopping Center Roofing
Shoppers and stock stay dry while a store reroof happens, which means night staging and tight water control over the sales floor at shopping centers across the Washington region.
Open details
Modified Bitumen Roofing
Multi-ply modified bitumen brings redundancy to flat roofs that see foot traffic, a fit for the institutional decks scattered across the District. We torch or cold-apply based on occupancy and fire constraints.
Open details
PVC Roofing
Heat-welded PVC stands up to ponding water and rooftop grease, which is why it suits restaurant and lab roofs around the capital. Hot-air-welded seams give it strength a taped lap cannot match.
Open details
Church and Religious Building Roofing
Sanctuaries and parish halls in the District often pair steep historic slopes with flat additions, so worship schedules and the building's age both shape how and when we phase the work.
Open details
Standing Seam Metal Roofing
Concealed-fastener standing seam carries no exposed penetrations and sheds the region's wind-driven rain cleanly, a durable choice for visible institutional and retail buildings around the capital.
Open details
Edge Metal, Coping & Gutters
Loose coping and failing edge metal are where DC's gusty fronts start peeling a membrane. We rebuild terminations and gutters to ANSI/SPRI wind standards so the perimeter holds in a storm.
Open details
Warehouse and Distribution Center Roofing
Acres of low-slope membrane cover the distribution buildings along the region's logistics corridors, where one leak threatens racked inventory. We survey and reseal these big roofs efficiently.
Open details
Spray Foam Roofing
Seamless spray polyurethane foam insulates and waterproofs in one pass while filling the low spots that pond on older DMV decks. A protective topcoat shields the foam from UV and traffic.
Open details
Roof Drains & Scuppers
Slow drains and undersized scuppers leave water sitting on flat DC roofs long after a downpour passes, and ponding shortens membrane life. We clear, repair, and right-size the drainage path.
Open details
Healthcare Facility Roofing
Hospitals and clinics cannot tolerate dust, odor, or infection-control lapses during roof work, so we coordinate with facilities staff on negative-pressure zones and after-hours staging at DC medical campuses.
Open details
EPDM
EPDM's flexibility holds up well through the region's wide temperature swings, from January freeze-thaw to August heat. We detail the seams and flashings that decide how long a black-rubber roof actually lasts.
Open details
Government and Municipal Building Roofing
Federal and municipal projects around the capital come with security clearances, prevailing-wage rules, and strict documentation, so we build the submittal and phasing plan around those requirements from day one.
Open details
Restaurant and Food Service Building Roofing
Kitchen exhaust coats a restaurant roof in grease that eats ordinary membranes, so we specify grease-resistant systems and keep the line cooking while the work overhead proceeds in the DC area.
Open details
Hotel and Hospitality Property Roofing
Guest comfort drives the schedule on hospitality roofs, where noise, fumes, and crane time all have to dodge check-in windows. We phase work over occupied wings across the Washington market.
Open details
Built-Up Roofing
Multi-ply built-up assemblies still earn their keep on heavy institutional decks around the capital. We weigh a fresh BUR build against a recover when the existing felts and flashings come up for review.
Open details
Office Building Roofing
Class A towers and suburban office parks alike depend on dry server rooms and quiet tenant floors, so we schedule crane lifts and noisy work around business hours throughout the DC metro.
Open details
Acrylic Roof Coatings
Plants and flex buildings across the Maryland and Northern Virginia corridors carry process loads, vents, and constant rooftop traffic, so we map equipment and walkways before scoping any repair or recover.
Open details
Insurance Claim Coordination
Storm claims move faster with clear documentation, so we photograph the damage, scope the repair, and speak the carrier's language alongside DMV property owners through the adjustment.
Open details
Manufacturing Facility Roofing
Production never stops for the roof, so work over a running line means protecting equipment, managing exhaust, and sequencing tear-off so no Maryland or Virginia plant takes water on an open deck.
Open details
Self-Storage Facility Roofing
Storage buildings protect tenants' belongings under long, low metal and single-ply roofs, so even a small leak is a claim. We keep these sprawling DMV roofs sealed across many units at once.
Open details
Skylight & Penetration Flashing
Skylights, pipes, and curbs are the first places a roof leaks, and the dense penetrations on DC institutional roofs multiply the risk. We reflash and seal each one to stop water at the detail.
Open details
TPO Single-Ply Roofing
A welded white TPO membrane reflects heat and resists the UV that bakes flat roofs through a Washington summer. We weld and probe every seam so the field stays watertight for the long haul.
Open details
Multifamily and Apartment Building Roofing
Apartment and condo roofs carry residents directly below, so leaks turn into tenant complaints fast. We work to limit noise and disruption while keeping multifamily buildings across the DMV watertight.
Open details
Auto Dealership Roofing
Showrooms stay open while the roof work happens, which means staging around customer parking and protecting the service bays below from any dust or water intrusion during a DC-area reroof.
Open details
Solar Roof Integration
Mounting a PV array means the roof has to outlast the panels, so we coordinate attachments, pathways, and warranties before solar goes on a Washington-area commercial roof.
Open details
School and K-12 Educational Building Roofing
Campus roofs get their heavy work in the summer break, so we compress tear-off and replacement into the window before students return to DC-area schools, with safety zoning around any occupied wing.
Open details